This is an archive of past FreeBSD releases; it's part of the FreeBSD Documentation Archive.

Common Problems
FreeBSD Handbook
Prev Chapter 14 Sound Next

14.5 Common Problems

14.5.1. I get an unsupported subdevice XX error!
14.5.2. I get a sb_dspwr(XX) timed out error!
14.5.3. I get a bad irq XX error!
14.5.4. I get a ``xxx: gus pcm not attached, out of memory'' error. What causes that?

14.5.1. I get an unsupported subdevice XX error!

One or more of the device nodes was not created correctly. Repeat the steps above.

14.5.2. I get a sb_dspwr(XX) timed out error!

The I/O port is not set correctly.

14.5.3. I get a bad irq XX error!

The IRQ is set incorrectly. Make sure that the set IRQ and the sound IRQ are the same.

14.5.4. I get a ``xxx: gus pcm not attached, out of memory'' error. What causes that?

If this happens, it is because there is not enough available memory to use the device.

Prev Home Next
Creating and Testing the Device Nodes Up Serial Communications

This, and other documents, can be downloaded from ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.

For questions about FreeBSD, read the documentation before contacting <questions@FreeBSD.org>.
For questions about this documentation, e-mail <doc@FreeBSD.org>.